Types Of Stitches; Straight Stitch; Straight Stretch Stitch - Texi Fox 25 Manual De Usuario

EN
ricot stitch

TYPES OF STITCHES

lace the fabric under the presser foot so
Tricot stitch
hat the edge will be slightly inside the right

STRAIGHT STITCH

and side of the presser foot.
Place the fabric under the presser foot so
Straight stitch
uide the work so the right hand stitches fall
PRESSER FOOT - UNIVERSAL
that the edge will be slightly inside the right
t the edge of the fabric.
1. Check presser foot (universal
hand side of the presser foot.
purpose presser foot).
Guide the work so the right hand stitches fall
2. Turn the handwheel toward
at the edge of the fabric.
you to bring the needle to it's
highest position.
3. Place the fabric under the
presser foot. Hold upper and
bobbin thread loosely.
4.
Lower the presser foot lever and
start sewing.
5.
Regulate the speed while
sewing.
6.
When you reach the end of seam, press the reverse lever to sew 3-4 stitches.
Raise the presser foot and position the fabric next to a
7. Raise the presser foot lifter.
stitching guide line on the needle plate.
8.
Turn the handwheel toward you to bring the needle to it's highest position. Pull the
Lower the needle into the fabric.
Lower the presser foot and smooth the thread towards the
fabric out from under the foot to the back of the machine. Cut the threads on the
back. Depress the foot control.
thread cutter.
Gently guide the fabric along the guide line letting the
fabric feed by itself.
riple strength stitch

STRAIGHT STRETCH STITCH

Triple strength stitch
For fastening the ends of seams, press the reverse stitch
PRESSER FOOT - UNIVERSAL
he stitch is sewn with two stitches forward
The stitch is sewn with two stitches forward
button and sew several reverse stitches.
and one stitch backward forming a seam
nd one stitch backward forming a seam
Raise the presser foot and remove the fabric, drawing the
Straight stretch stitch is far stronger
that does not rip easily. threads to back.
hat does not rip easily.
Garments should be basted for fitting before
than an ordinary straight stitch
arments should be basted for fitting before
seaming.
eaming. because it locks three times -
forwards, backwards and forwards.
It is particularly suitable for
reinforcing the seams of portswear
The threads are cut the proper length for starting the next
in stretch and non-stretch fabrics,
seam.
and for curved seams which take
a lot of strain. Use this stitch also to
top-stitch lapels, collars and cuffs to give a
professional finish to your garments.
76
UTILITY STITCHES
UTILITY STITCHES
UTILITY STITCHES
Texi Fox 25
Machine Setting
Machine Setting
D
1~4
Machine Setting
D
1~4
A 2~6
B
Machine Setting
Machine Setting
A B
A B
2~6
2~6
0.5~1.5
0.5~1.5
1.5~4
S S
S S
13
15
15