Advanced Configuration; Mode Setup - Bahco TASMB Serie Traducción De Las Instrucciones Originales

TASMB AND TAWMB SERIES

ADVANCED CONFIGURATION

Note: If wrench has been locked (see Preset Lock and Job Mode), a password entry is required
1. From target torque or angle screen, press and hold ENTER button for 3 seconds.
2. Highlight CONFIGURE menu selection using UP/DOWN buttons.
Menu Selections:
MODE SETUP - Displays wrench mode setup menu.
PRESET LOCK - Displays Preset lock menu.
DELETE PRESETS - Displays delete all presets menu.
JOB MODE - Displays Job mode menu.
MENU LOCK – Password protects all menus.
CALIBRATION - Displays wrench calibration menu (password protected).
SET DATE/TIME - Displays clock date and time entry screens.
CHANGE PASSWD - Displays change password menu.
BLE ENABLE - Enables or disables BLE radio.
menu selection is highlighted.
power is off.

MODE SETUP

disable Torque THEN Angle mode and Torque AND angle mode.
2. Mode Setup menu is displayed.
Menu Selections:
TQ-% SETUP - Displays target torque minus tolerance entry screen.
TQ+% SETUP - Displays target torque plus tolerance entry screen.
ANG-% SETUP - Displays target torque minus tolerance entry screen.
ANG+% SETUP - Displays target torque plus tolerance entry screen.
THEN DISABLED - Displays THEN Mode enable/disable screen.
AND DISABLED - Displays AND Mode enable/disable screen.
3. Use UP/DOWN buttons to highlight menu selections.