Stryker 0233–050–064 Manual De Instrucciones página 8

3
S S e e t t u u p p
W W a a r r n n i i n n g g
Before using the cable with an endoscope, check the outer surface of the endoscope
to ensure there are no rough surfaces, sharp edges, or protrusions.
Keep fingers away from the light source cable port when inserting the cable, as the
clamp may inadvertently deploy and cause injury.
1. Insert the light source end of the cable into the cable port.
• If using a Stryker light source, turn the lever on the light source clockwise to lock
open the cable clamp. The port will automatically tighten when the cable is fully
inserted.
• If using another manufacturer's light source, the appropriate light source adapter
must first be attached to the Universal Fiberoptic Cable (0233-050-090).
2. Connect the appropriate scope adapter to the endoscope.
3. Attach the endoscope end of the cable to the scope adapter.
N N o o t t e e : : F F o o r r d d i i s s a a s s s s e e m m b b l l y y , , f f i i r r s s t t p p o o w w e e r r o o f f f f t t h h e e l l i i g g h h t t s s o o u u r r c c e e ( ( o o r r p p l l a a c c e e i i t t i i n n S S t t a a n n d d b b y y m m o o d d e e ) ) , ,
t t h h e e n n f f o o l l l l o o w w t t h h e e i i n n s s t t r r u u c c t t i i o o n n s s a a b b o o v v e e i i n n r r e e v v e e r r s s e e o o r r d d e e r r . . T T u u r r n n t t h h e e l l e e v v e e r r o o n n S S t t r r y y k k e e r r l l i i g g h h t t
s s o o u u r r c c e e s s t t o o r r e e l l e e a a s s e e t t h h e e c c a a b b l l e e f f r r o o m m t t h h e e p p o o r r t t . .
EN- 6