Display Function Mode; Parameter Display Mode - Roger Technology H70/104AC Instrucciones Y Advertencias Para El Instalador

10

Display function mode

• Parameter display mode

PARAMETER
PARAMETER
See chapter 13 for detailed descriptions of parameters.
• Command and safety device status display mode
COMMAND STATUS
AP PED
PP
CH
ORO
POWER ENC
H70/104AC)
• TEST mode
TEST stops the gate. Pressing the button again enables TEST mode.
device is activated.
The status of the safety devices/inputs is shown on the right hand side of the display. The number of the terminal
reached the gate open limit switch
54
VALUE
SAFETY DEVICE STATUS
FT1 FT2
COS1
COS2
SB STOP
The command signal status is shown on the left hand side of the display
letters AP appear on the display.
or gate closed limit switch
(Sb)
COMMAND STATUS:
The command status indicators on the display (segments
opening are normally off. They illuminate
SAFETY DEVICE STATUS:
The safety device status indicators on the display
(segments FT1/FT2=photocells
edge
or is shown on the display to indicate that the gate has
.
activated
Release handle or lock open.
STOP
Sensing edge COS1
Sensing edge COS2
Photocell FT1
Photocell FT2
More than 3 limit switches activated
Gate completely open / Gate open limit switch activated
Gate completely closed / Gate closed limit switch
activated
sensing