Travel Acquisition - Roger Technology H70/104AC Instrucciones Y Advertencias Para El Instalador

NOTA
the next device is displayed. Any further alarm states are also displayed with the same logic.
Press the TEST button again to exit test mode.
• Standby mode
Press UP + - to reactivate the control unit.
POWER
11

Travel acquisition

1. Select the position of the motor relative to the gate with the parameter
is with the motor installed on the right hand side of the gate (seen from interior side).
2. Check that the operator present function is not enabled (
3. Install mechanical stops in both the open and closed positions.
4. Move the gate into an intermediate position.
5. Press TEST (see TEST mode in chapter 10) and check the command signal and safety device states. If any safety
and ).
6.
SELF-ACQUISITION PROCEDURE WITH ENCODER ENABLED, WITH OR WITHOUT LIMIT
A
SWITCHES
(see paragraph 11.1)
SELF-ACQUISITION PROCEDURE WITH LIMIT SWITCHES, WITHOUT ENCODER
B
11.2).
SELF-ACQUISITION PROCEDURE WITHOUT LIMIT SWITCHES AND WITHOUT ENCODER
C
(see paragraph 11.3).
).
.
. The default setting for this parameter
(see paragraph
(
55