Function Buttons And Display; Switching On Or Commissioning - Roger Technology H70/104AC Instrucciones Y Advertencias Para El Instalador

CONTACT
29 30 31 32 33 34 35
29 34 35
RECEIVER CARD
8

Function buttons and display

UP
DOWN
PROG
• Press the UP and/or DOWN
•
• Press and hold the + or -
•
•
9

Switching on or commissioning

Power the control unit.
DESCRIPTION
Use a 4x0.5 mm 2 cable to connect the limit switch to the control unit.
The gate stops when the limit switch is activated.
The terminal 24 V AC input may only be used to power ROGER TECHNOLOGY magnetic limit
switches.
The ROGER TECHNOLOGY magnetic limit switch is equipped with a plug-in connector. If used with
the H70/105AC
N.B.:
COM, but disable them by par. 72.
The limit switch function depends on the setting for parameter
FC1 = Opening limit switch
FC1 = Closing limit switch
The optical encoder is enabled by default (
WARNING! Always disconnect from electrical power before disconnecting or connecting the
encoder cable.
Connector for plug-in radio receiver board.
–
–
TEST
buttons to view the parameter you intend to modify.
DO NOT jumper contacts FC1-COM e FC2-
).
BUTTON DESCRIPTION
UP Next parameter
Previous parameter
DOWN
+ Increase value of parameter by 1
- Decrease value of parameter by 1
PROG Programme travel
TEST Activate TEST mode
See chapter 7.
.
FC2 = Closing limit switch
FC2 = Opening limit switch
or DOWN button. The
53