Side Stand - Malaguti XTM X3M Manual De Uso Y Mantenimiento

SIDE STAND

C
Located on the left hand side of the vehicle, it is controlled by
micro switch C, which prevents engine starting if it is not in closed
position
Never remove or tamper with this safety device for any
reason whatsoever.
Before operating the side stand, make sure the ground is suitably
flat and stable. Soft soil, gravel or asphalt softened by heat, for
instance, can cause the vehicle to fall and be seriously damaged.
If you are parking on a slope, make sure the rear wheel is parked
on the lower side.
To operate the side stand, hold the handlebar with both hands and,
at the same time, press your foot onto the lever to "guide" the side
stand to its fully extended position. Tilt the vehicle until the side
stand is resting on the ground.
To put side stand in „idle" position (horizontal), tilt the vehicle
towards the right, guide the side stand to its automatic return
position and make sure it is idle.
All manuals and user guides at all-guides.com
INSTRUMENT AND CONTROL FUNCTIONING
ENGLISH
Check the spring holding the side stand in place (trac-
tion spring) on a regular basis.
Do not sit on the vehicle with the side stand operated.
1
2
3
4
5
6
7
8
9
21