Digital Instrument Board; Important - Malaguti XTM X3M Manual De Uso Y Mantenimiento

INSTRUMENT AND CONTROL FUNCTIONING

DIGITAL INSTRUMENT BOARD

This new digital instrument board offers several additional func-
1
tions - compared to traditional ones - through which driver may
optimally manage his/her vehicle. To select the functions shown
on the display, press the Mode button on the front side of the left
2
hand control (see page 16).
Available functions are:
3
0-40 (acceleration from 0 to 40 km/h),
TIME (clock),
4
LAP (chronometer),
AVE (average speed),
TD (partial distance),
5
TOD (total distance),
GRAPHIC BAR (2 functions: battery charge level, engine speed).
6
In countries where the BRITISH system applies, speed is
displayed in mph. Select the type of vehicle (Enduro or
7
SuperMotard). You can check this on the anti-tampering
label under the vehicle's seat (see page 55). The digital
instrument board only works if the battery is connected.
8
If the battery is flat, replace it immediately. When the
battery is replaced or the fuse is removed, power is
disconnected; any memorised settings, with the excep-
9
tion of the total distance travelled, will be reset.
Replace the flat battery with a charged one; if the problem re-
mains, call an authorised MALAGUTI Dealer.
Do not use your vehicle when no function appears on
the display or when functions appear partially, since the
instrument board is not in the condition to provide suffi-
cient information about your vehicle.
12
All manuals and user guides at all-guides.com
Setting
Power up the instrument board by connecting the battery to the
vehicle's cables. Put the key in the ignition switch and turn it to
The names of stored models appear successively on the display,
namely
vehicle (Supermotard/Enduro). You can check this on the anti-tam-
pering label under the
When the code of your model appears on the display, press the
MODE button, to make your selection. If you choose the wrong model,
you will be shown improper information (speed, km, etc.). If you
choose the wrong model, turn the panel off, wait for about two
minutes and repeat the above operations in the correct manner.
Mile or kilometre selection
If you are driving in countries with different measurement systems,
you can change the unit of measurement of speed (instant and
average) and distance from kilometres to miles and vice versa. To
make your selection, first of all the vehicle must be stationary. Now
hold the MODE button down for 5" after selecting the TOD function.
When "mph" and "Km/h" appear, give the MODE button short
presses until the unit of measurement starts flashing. Hold the
MODE button down to save your selection. The instrument board
will return to its normal display mode. Any stored information (with
the exception of TOD) will be reset.
ENGLISH
"Mtrd" and "Endr" (Supermotard/Enduro). Select the type of
vehicle's seat (see page 55).
These operations must be repeated every time the bat-
tery is disconnected.
IMPORTANT: using a unit of measurement that differs
from the one used in the country where you are driving
may lead to improper calculations, especially concerning
the vehicle's speed. Consequences include exposure of
the driver and others to dangers, as well as fines.
.