Useful adjustment settings
Blue LED Dimmer
You can adjust the brightness of the POWER ON indicator
depending on the brightness level of the viewing area.
1
Press HOME MENU.
2
Select "Option" (/ then ENTER).
3
Select "Blue LED Dimmer" (/ then ENTER).
4
Select "High", "Mid" or "Low" (/ then ENTER).
5
Press HOME MENU to exit the menu.
Orbiter
This function automatically shifts the image little by little to reduce
the occurrence of the burning.
1
Press HOME MENU.
2
Select "Option" (/ then ENTER).
3
Select "Orbiter" (/ then ENTER).
4
Select "On" (/ then ENTER).
5
Press HOME MENU to exit the menu.
• To cancel this function, select "Off" in step 4.
Note
• When the Orbiter function is set to "On", the image may appear
to drop slightly on the screen.
• This function does not operate when PC signals are received.
Video Pattern
You can display the Video Pattern screen that also helps eliminate
after-image when it occurs.
1
Press HOME MENU.
2
Select "Option" (/ then ENTER).
3
Select "Video Pattern" (/ then ENTER).
A confirmation screen appears.
4
Select "Start" (ENTER).
The Video Pattern screen displays.
Note
• The system is automatically placed into standby one hour after
the Video Pattern screen has started.
• While the Video Pattern screen is on, no buttons operate except
a on the remote control unit, STANDBY/ON and a on the
plasma television.
• To cancel the Video Pattern screen, press a on the remote
control unit, STANDBY/ON or a on the plasma television.
• The Video Pattern timer has priority over the sleep timer. When
the Video Pattern timer is on, the sleep timer becomes
ineffective.
All manuals and user guides at all-guides.com
Sleep Timer
When the selected time elapses, the Sleep Timer automatically
places the system into the standby mode.
1
2
3
Select "Off" (cancel), "30 min", "60 min", "90 min", or "120 min".
4
• Five minutes before the selected time elapses, the remaining
• To check the remaining time, perform steps 1 and 2. After
• The SLEEP indicator on the front of the plasma television lights
Using a password
The plasma television provides the Child Lock function for
preventing children from watching inappropriate programmes. You
need to enter a password when watching programmes with "Block"
specified. Before the system is shipped, "1234" is preset as the
factory-default password. You can however, change the password
as you want.
You will need to enter the password before using the "Auto
Installation", "Analogue TV Setup" or "Password" functions from
the HOME MENU. This is to prevent unauthorized changes to the
settings.
Entering a password
You will need to enter the password after selecting a channel
blocked with the Child Lock function, and before you can use some
of the menu functions.
• Enter your four-digit password using buttons 0 to 9.
• If you fail to enter the correct password three times, "Invalid
• If the password entry screen disappears before entry, you may
Press HOME MENU.
Select "Sleep Timer" (/ then ENTER).
Select the desired time (/ then ENTER).
Press HOME MENU to exit the menu.
Note
time appears every minute.
checking the time, press HOME MENU to restore the previous
display.
orange when the sleep timer is set.
Please Input Your Password.
Note
password." appears, and the menu is closed. In order to display
the password entry screen again to unlock the password, select
the blocked channel or open the menu again.
recall it by pressing ENTER.
09
39
En