Areas Of Use - Viking MF 440 Instrucciones De Uso

All manuals and user guides at all-guides.com
and front-mounted accessories. Two positions:
1. Press the right part of the switch – the
power take-off is engaged. The symbol
will light up.
2. Press the left part of the switch – the
power take-off is disengaged.
10. CUTTING HEIGHT ADJUSTMENT
(MF 480)
The machine is equipped with a control for using
the cutting deck with electrical cutting height ad-
justment (available as an accessory).
The switch is used to adjust the cutting
height in continuously variable positions.
The contact used for connecting the cutting deck is
mounted on the right side, in front of the front
wheel (fig. 9).
11. DISENGAGING LEVER
(MF 460, MF 480)
A lever for disengaging the variable transmission.
Enables the machine to be moved by hand without
the help of the engine. Two positions:
1. Lever pressed in – transmis-
sion engaged for normal opera-
tion.
2. Lever pulled out – transmis-
sion disengaged. The machine
can be moved by hand.
The machine may not be towed over long distances
or at high speeds. The transmission could be dam-
aged.

AREAS OF USE

The machine may only be used for the following
tasks using the genuine accessories stated.
1. Mowing
With cutting deck AMM 436, AMM 442 or
AME 442 (MF 480).
2. Snow clearance
With snow blade ASS 447. Snow chains
ASK 416 and frame weights AMG 135 recom-
mended.
The maximum vertical load on the towing hitch
must not exceed 100 N.
ENGLISH
The maximum over-run load on the towing hitch
from towed accessories must not exceed 500 N.
NOTE! Before using a trailer – contact your insur-
ance company.
NOTE! This machine is not intended to be driven
on public roads.
STARTING AND OPERATION
ENGINE CASING
To inspect and maintain the engine and battery, re-
move the engine casing. The engine must not be
running when the casing is removed.
Dismantling:
1. Fold up both casing locks at the rear edge
(fig. 4).
2. Pull the engine casing back a little first. Then lift
it off.
Assembly:
1. Fold the seat forward.
2. Align the casing's upper, front pins with the
slots in the front engine casing (fig. 5). Leave ap-
prox. 2 cm clearance.
3. Guide both conical side pins into the holes in the
front engine casing. Then press the entire casing
forwards.
5. Finally fold down both casing locks (fig. 4.)
The machine may not be operated un-
less the engine casing is mounted. Risk
of burns and crushing injuries.
FILLING THE FUEL TANK
Always use lead-free petrol. You must never use 2-
stroke petrol mixed with oil (fig. 6).
NOTE! Bear in mind that ordinary lead-free petrol
is a perishable; do not purchase more petrol than
can be used within thirty days.
Environmental petrol can be used, i.e. alkylate pet-
rol. This type of petrol has a composition that is
less harmful for people and nature.
Petrol is highly inflammable. Always
store fuel in containers that are made
especially for this purpose.
EN
15