Instrument And Indicator Table - APRILIA SR 50 Manual Del Usuario

INSTRUMENT AND INDICATOR TABLE

Description
Direction indicator warning light (
Mixer oil reserve warning light
Total kilometres odometer
Speedometer
Low beam warning light
High beam warning light
(in the countries where required) (
Low fuel warning light
Fuel level indicator
Coolant
temperature indicator
Diagnostic system warning light
(injection check)
use and maintenance SR 50
20
All manuals and user guides at all-guides.com
Function
) It blinks when the direction indicators are on.
It comes on with the ignition switch in position "
button " " pressed, thus checking the correct operation of the bulb. If the light does not come
on during the starting, provide for replacing the bulb.
CAUTION
( )
button " " has been released, or if it comes on during normal functioning, this means that
the mixer oil reserve is being used; in this case, top up the mixer oil tank, see p. 28 (MIXER
OIL).
It indicates the total number of kilometres covered.
It indicates the driving speed.
( ) It comes on when the headlight is in low beam position.
) It comes on when the headlight is in high beam position.
( ) It comes on when the quantity of fuel left in the tank is about 2
( ) It indicates the approximate fuel level in the tank.
It indicates the approximate temperature of the coolant in the engine.
When the pointer starts moving beyond the "min" level, the temperature is sufficient for driving the
vehicle. The normal running temperature range is indicated by the central area of the scale.
If the pointer reaches the red area, stop the engine and check the coolant level, see p. 31
(COOLANT).
( )
CAUTION
If the maximum allowed temperature is exceeded ("max" red area of the
scale), the engine may be seriously damaged.
It lights up for a few seconds when the ignition switch is turned to the "
light comes on, follow the instructions given on page 21 (INJECTION CHECK WARNING LIGHT).
CAUTION
attempt to start it but contact an aprilia dealer.
If the warning light comes on and does not go out after the start push
If the light does not go out, the vehicle is malfunctioning. Do not
", one brake lever pulled and the start push
l
.
" position. If the warning