Changing The Tail Light Bulb; Changing The Number Plate Bulb - APRILIA SR 50 Manual Del Usuario

2
1
CHANGING THE TAIL LIGHT
BULB
Carefully read p. 71 (BULBS).
Only for the rear stoplight:
NOTE
Before changing a bulb, check the
fuse, see p. 70 (CHANGING THE FUSES)
and the effective operation of the stoplight
switches, see p. 63 (CHECKING THE
SWITCHES).
The tail light consists of two units. Each unit
contains:
- one parking light bulb (1);
- one stoplight bulb (2).
To change them, proceed as follows:
◆ Position the vehicle on the centre stand,
see p. 43 (POSITIONING THE VEHICLE
ON THE STAND).
◆ Unscrew and remove the screw (3).
All manuals and user guides at all-guides.com
2
3
4
1
NOTE
screen, proceed carefully in order not to break
the cog.
◆ Remove the protection screen (4).
◆ For the stoplight bulb (2) only, slightly press
the bulb and rotate it anticlockwise.
◆ Remove the bulb from its seat.
NOTE
Insert the bulb in the socket, making
the two bulb pins match the relevant guides
on the socket.
◆ Correctly install a new bulb of the same
type.
Upon reassembly, correctly position the
protection screen in its seat.
Tighten the screw (3) carefully, without
exerting too much pressure, in order to
avoid damaging the protection screen.
2
1
While removing the protection
CAUTION
6
5
CHANGING THE NUMBER
PLATE BULB
(in the countries where required)
Carefully read p. 71 (BULBS).
CAUTION
To extract the bulb socket, do not pull the
electric wires.
◆ Working on the inner lower side of the
number plate holder, grasp the bulb socket
(5), pull it and extract it from its seat.
◆ Withdraw the bulb (6) and replace it with a
new one of the same type.
use and maintenance SR 50 75