Removing The Lower Handlebar Cover - APRILIA SR 50 Manual Del Usuario

1
3
2
4
9
REMOVING THE LOWER
HANDLEBAR COVER
Carefully read p. 44 (MAINTENANCE).
◆ Remove the cover support element, see
p. 55 (REMOVING THE COVER SUPPORT
ELEMENT).
NOTE
Support the front fairing (1), to
prevent it from accidentally falling down.
◆
Unscrew and remove the two screws (2)
CAUTION
Handle the plastic or painted components with
care and avoid scraping or damaging them.
◆ Remove the front fairing (1).
◆ Take the spacer (3).
◆
Unscrew and remove the screw (4).
◆
Rotate the handlebar completely
rightwards, unscrew and remove the screw
(5) (with shorter diameter) and the screws
(6), (7) and (8).
use and maintenance SR 50
56
All manuals and user guides at all-guides.com
11
2
8
NOTE
Upon reassembly, fit the screws (5)
(with shorter diameter) in the relevant seats.
◆ Rotate the handlebar in central position,
withdraw the lower handlebar cover (9)
from the front and remove it.
PARTIAL REMOVAL OF THE UPPER
HANDLEBAR COVER
Carefully read p. 44 (MAINTENANCE).
◆ Remove the rear-view mirrors, see p. 58
(REMOVING THE REAR-VIEW MIRRORS).
◆ Remove the lower handlebar cover, see
beside (REMOVING THE LOWER
HANDLEBAR COVER).
◆
Disconnect the two electric terminals
(10).
12
7
5
CAUTION
The upper handlebar cover (11) (complete
with switches, instruments and indicators)
remains connected with the speedometer
cable and with the electric cables, which
makes it impossible to remove it
completely.
Proceed with care in order to avoid
damaging the components.
◆ Paying attention to the two switch
connections (12), lift the upper handlebar
cover and rotate it forwards, then rest it
on the front shield.
NOTE
Upon reassembly, when positioning
the upper handlebar cover, route the electric
terminal cables (10) behind and under the
handlebar.
10