Blatchford LINX22L1S Manual Del Técnico Ortoprotésico página 14

7 Battery Charging
Fully charge the battery before first use.
We recommend that the device should be fully charged
every night. It should take 8 hours to charge fully (from fully
discharged). We also recommend battery charging whenever
convenient.
Step-by-Step Guide:
1. Lay the limb on a flat surface.
2. Ensure the mating surfaces of the magnetic charging
connector and terminal are clean (see Section 5).
3. Magnetically join the charging connector to the charging
terminal at the posterior of the knee and check alignment is
correct (see Section 7.1).
4. Switch the Battery On/Off switch to ON [I].
5. Check the Battery Charger LED is flashing green to confirm
the battery is charging.
6. Refer to table below to ensure Limb is charging.
7. Disconnect from the charger when charged sufficiently.
8. Wait for 30 seconds while observing the device LED
changing color as indicated:
Red
Device
LED
9. After a successful reset sequence, 2 short beeps will be
heard (if this alert is not disabled; see* below).
10. If reset sequence is unsuccessful or the LED remains Red,
switch the battery OFF [O] then ON [I] and repeat from
step 8.
Battery Charger LED
Yellow
Green > fast flashing
Green > slow flashing
Green
Yellow > fast flashing
Note... If the charger LED is yellow and the Limb is making
a clicking noise check that the Battery switch is in the
position.
(continued)
Blue Red
Charging State
Standby
Fast charging
Close to full charge
Maintain (trickle charge)
Error (Ensure Battery Switch is
ON [I])
Green Off
ON [I]
14
Battery
Charger
Magnetic
Connector
Battery
Charger
LED
Note... Do not move
or don the limb while
reset is processing
otherwise this will
prolong the reset
time.
Device
Device
LED
*The user can enable or
disable the audible reset
confirmation by pressing and
holding the [+] and [-] buttons
simultaneously for 2 seconds.
The change will be confirmed
by 2 short beeps.
938353V2APK1/1-0321