Factory Reset - Blatchford LINX22L1S Manual Del Técnico Ortoprotésico

9.2.4

Factory Reset

WARNINGS
1. Factory Reset will delete all
calibration data and return settings
to the factory defaults. The knee
will be in a free state with no stance
support during Factory Reset.
2. After a factory reset do not attempt
to walk on the limb until it has
been suitably reprogrammed.
Refer to Flow Diagram B.
To enter the button-programming mode for
factory reset:
• Power on the device, (wait for the power
on LED color sequence to complete,
ending in LED OFF then,
• Press and hold [+] and [-] simultaneously
three times in quick succession (waiting for
two short beeps to sound before releasing
each press).
The limb now enters Prepare for Factory Reset
mode indicated by three medium beeps and
LED flashing alternating purple and red.
Note... This is the last point in the flow at
which you can cancel Factory reset (to cancel
and exit, press and hold [-], two long beeps
confirms exit.)
To proceed with Factory Reset:
• Ensure the user is sitting down with their
knee flexed.
• Press the [+] button to move to the Start
Factory Reset stage
(5 short beeps and LED steady purple
confirms).
• Flex and extend the leg until two long
beeps are heard.
Factory reset is now complete and
the program exits Factory Reset mode
automatically and the LED extinguishes.
Flow Diagram B—Button-
Programming for Factory Reset
Power On
Press
Press
Press
Enter Button-programming
mode for Factory Reset
LED alternating
red/purple
Prepare for
Factory Reset
Get user to sit with knee flexed
Factory Reset
Flex and extend leg until next
audible alert
Factory Reset
Complete
Note... In Prepare for Factory Reset stage only, if
no activity/button press is detected within a set
period of time, then program automatically exits.
27
LED Power-ON
[ + ] [ - ]
Sequence
2
+
[ + ] [ - ]
2
Audible
+
Response
2
[ + ] [ - ]
3
[ + ]
1
5
Start
2
Moves to next stage
automatically
Exit Factory
Reset Mode
938353V2APK1/1-0321
Cancel Reset
option
2
[ - ]