Setting Up The Device - Blatchford LINX22L1S Manual Del Técnico Ortoprotésico

9.1.3

Setting up the Device

Program
1. Select [Program] from the Hub.
2. Check bench alignment:
It is important the device is aligned
correctly before calibrating (see Section 8),
then press:
3. Adjust yield resistance for sitting in a chair,
then press:
4. Press [Start Walk] and walk until two beeps
are heard. (Adjust dynamic alignment and
recalibrate if required).
If realignment is not required, press
[Continue].
5. Adjust foot plantarflexion and dorsiflexion
settings as required, then press [Continue
Limb Calibration].
6. Press [Continue Walk] and walk until 2
beeps are heard. Extra beeps will be heard
upon saving of settings.
Programming is now complete, but you
can now return to the hub screen and fine
tune settings as necessary, and/or save your
settings, etc.
Fine Tune
1. Select [Fine Tune] from the Hub.
• Walking Speeds
• Stance Settings
Program
• Ramp Settings
• Stairs Descent
• Standing Support.
• Foot Settings
Next
Save and Restore
1. Tap on [Save and Restore] button from the
Next
2. Tap on [Save from Limb] button to save
3. Select a table entry to review and restore
22
Fine Tune allows refinement of the
following settings:
Hub:
settings from connected limb.
previously saved settings.
938353V2APK1/1-0321