Cycling Mode; Training Mode - Blatchford LINX22L1S Manual Del Técnico Ortoprotésico

10.2 Cycling Mode

WARNING: In Cycling Mode there is
NO yield resistance.
To enable/disable Cycling Mode via the
Linx Programming App:
• Select [User Modes] from the Hub.
To enable/disable Cycling Mode:
• Tap Cycling Mode [Enable] to enable.
• Tap Cycling Mode [Disable] to disable.
To test Cycling Mode using the app:
• Swipe right to expose the User Modes test
buttons, ask the User to flex the knee to 45
degrees or greater (typically by sitting) then
tap on the [Cycling Mode Test]
button.
WARNING: After exiting Cycling Mode, always test/confirm that the limb is
operating normally again before walking.

10.3 Training Mode

WARNING: In Training Mode,
the limb has a predefined fixed
pneumatic resistance setting
which does not adapt to changes
in walking speed. Also, Standing
Mode is not active in Training
mode.
To enable/disable Training Mode via the
Linx Programming App
• Select [User Modes] from the Hub.
To enable/disable Training Mode:
• Tap Training Mode [Enable] to enable.
• Tap Training Mode [Disable] to disable.
To test Training Mode using the app:
• Swipe right to expose the User Modes test
buttons, then tap on the [Training
Mode Test] button.
WARNING: After exiting Training Mode, always test/confirm that the limb is
operating normally again before walking.
User activation of Cycling Mode
To activate/de-activate Cycling Mode use the
[-] button on the knee module, as follows:
To switch On Cycling Mode:
WARNING: In Cycling Mode there is
NO yield resistance.
• Press the [-] button 4 times (each time
pressing until the device responds with a
single short beep).
• 4 medium beeps then sound to confirm
that Cycling Mode is ON.
To switch Off Cycling Mode:
• Press and hold the [-] button.
• 2 long beeps then sound to confirm that
Cycling Mode is OFF and normal operation
has resumed.
User activation of Training Mode:
To activate/de-activate Training Mode use the
[-] button on the knee module, as follows:
To switch ON Training Mode:
• Press the [-] button 5 times (each time
pressing until the device responds with a
single short beep).
• 5 medium beeps then sound to confirm
that Training Mode is ON.
To switch OFF Training Mode:
• Press and hold the [-] button.
• 2 long beeps then sound to confirm that
Training Mode is OFF and normal operation
has resumed.
29
938353V2APK1/1-0321