TOHATSU MFS 25B Manual Del Propietário página 47

46
ENGINE OPERATION
ENOW00050-0
CAUTION
Do not tilt up outboard motor during opera-
tion, or engine may be damaged from over-
heating due to lack of sufficient cooling
water.
ENOM00063-0
Tilt down
Pull the reverse lock lever upward until it
stops. (This is the tilt down position.) Now,
lift up the outboard motor slightly, and then
allow gravity to lower it for you.
1
2
1. Tilt down position
2. Tilt up position
3. Reverse lock lever
ENOM00064-0
Shallow water operation
ENOW00051-0
WARNING
During shallow water operation, be careful
not to place your hand between the swivel
bracket and the stern bracket.
Be sure to tilt the outboard motor down
slowly.
All manuals and user guides at all-guides.com
3
ENOF00060-0
ENON00019-0
Note
Slow down to trolling speed, and shift into
neutral before setting outboard motor to
shallow water drive position.
ENOW00052-0
WARNING
Run at lowest possible speed when
using shallow water drive.
Tilt lock is disabled when in shallow
water drive position.
When driving shallow water, be careful
not to strike outboard motor against sea
bottom, or propeller may be pushed out
of water, resulting in loss of control.
1. Shallow water running position:
Put the reverse lock lever in the tilt up
position, and tilt up the outboard motor
to put the outboard motor in the shal-
low water running position.
1
1. Reverse lock lever
2. Return to normal running position:
Put the reverse lock lever in the tilt
down position, slightly lift up the out-
board motor, and then put it down.
ENOF00061-0