Nespresso ESSENZA PLUS Manual Del Usuario página 22

Troubleshooting
EN
No light indicator.
No coffee, no water.
Coffee comes out very slowly.
Coffee is not hot enough.
Capsule area is leaking (water in capsule container).
All 3 beverage buttons blinking fast.
Descaling alert blinking (descaling alert level 1).
Descaling alert steady light (descaling alert level 2).
Irregular blinking.
No coffee, just water runs out (despite inserted capsule).
22
- Check the power outlet, plug, voltage, and fuse. In case of problems, call Nespresso.
- First use: fill water tank with warm water (max. 55° C) and run through machine according to instructions on page 12.
- Water tank is empty. Fill water tank.
- Descale if necessary; see Descaling section.
- Flow speed depends on the coffee variety.
- Descale if necessary; see Descaling section.
- Preheat cup.
- Descale if necessary.
- Position capsule correctly. If leakages occur, call Nespresso.
- Machine is in error, overheating or in an environment below 0°C / 32°F. Please wait for all buttons to stop blinking; this may take a few minutes.
- If buttons still blink after a few minutes, unplug and replug the machine.
- If problem persists, call Nespresso.
- Machine triggers descaling alert according beverages consumption usage. Descale machine.
- Machine triggers descaling alert according beverages consumption usage. Descale machine immediately to avoid machine performance and coffee
quality decrease.
- Send appliance to repair or call Nespresso.
- In case of problems, call Nespresso.