Roger Technology EDGE1/BOX Instrucciones Y Advertencias Para El Instalador página 77

Enabling of regular maintenance activation
N.B: Parameter visible if any password other than the default password is set (Parameter
N.B.: in the event of a reset to restore the default parameters, this parameter must be set again manually.
When the manoeuvre hour limit (set by
1500 manoeuvre hours).
IMPORTANT
The message
To reset the alarm, release the protection by inputting the password (
is displayed, followed by the messages
is displayed.
If the TEST key is released,
The number of hours is stored by the control unit, and the count is reset.
N.B.: When 9990 hours of operation are exceeded, the maintenance alarm is disabled entirely.
Disabled.
Maintenance enabled for a period = parameter value
Maintenance enabled for a period = parameter value
Adjustment of regular maintenance activation hour counter
N.B: Parameter visible with parameter
N.B.: in the event of a reset to restore the default parameters, this parameter must be set again manually.
Disabled.
from 10 to 990 hours with parameter
from 100 to 9900 hours with parameter
Restoring factory default values
NOTE This procedure is only possible is NO data protection password is set.
+
P1
P2
-
Warning! Restoring default settings cancels all settings made previously except for parameter
that all parameters are suitable for the installation.
• Turn off the power.
•
• The display flashes after 4 s
• The default factory settings have now been restored.
N.B.
HW version.
Year of manufacture.
Week of manufacture.
Serial number.
FW version.
View manoeuvre counter
The number consists of the values of the parameters from
N.B.
IMPORTANT
Manoeuvres performed.
Example x100 = 12.300 manoeuvres.
and ) is exceeded, the visual maintenance signal is activated (e.g. every
appears on the display and the alarm is not reset.
x10 hours.
x100 hours.
or .
.
.
x4 s
.
) and press TEST for 5 s. The message
to .
to multiplied by 100.
÷ ).
77