Roger Technology EDGE1/BOX Instrucciones Y Advertencias Para El Instalador página 81

PROBLEM
The gate does not
open or close.
Acquisition proce-
dure does not com-
plete correctly.
Remote control
has limited range
and does not work
while automated
gate is moving.
is not working.
With gate stops,
(ASSt)
-
gular duty cycle (1
s on / 4 s off).
Message to-
gether with audible
(POS1)
warning signal.
(with SMARTY/
EMA only)
(POS2)
Gate open indica-
tor lamp does not
work.
Gate does not per-
form desired ma-
noeuvre.
N.B.
The next time a command is received, the alarm reappears on the display if the problem has not been resolved.
ALARM POSSIBLE CAUSE
Incorrect installation of the motors
Position detected of MOTOR 2 incon
gruent with travel length.
Incorrect installation of the motors
Flat batteries.
(btLO)
.
TEST button pressed accidentally.
Safety devices in alarm state.
Excessive voltage drop.
Travel length error.
The radio transmission is impeded by
metal structures and reinforced con
crete walls.
Flat batteries.
wires disconnected.
Maintenance alarm.
reading is in progress.
reading is in progress.
Bulb blown or wires disconnected.
Motor leads crossed.
Incorrect selection of the battery type. Change the value of the parameter
ACTION
Verify the correct installation of the motors.
must not be installed to open the door towards
Check the setting of parameter
the learning procedure.
Replacing the encoder is recommended if the
problem persists.
Verify the correct installation of the motors.
must not be installed to open the door towards
Wait for mains power to be restored.
Repeat acquisition procedure.
Press the TEST button and check the safety
the safety devices.
Repeat acquisition procedure.
Check mains voltage.
Move gate into completely closed position and
repeat the procedure.
Install the antenna.
Replace the transmitter batteries.
Perform a maintenance programm.
To reset the alarm, release the protection by
inputting the password (
TEST for 5 s. The message
followed by the messages
TEST key until is displayed.
If the TEST key is released,
the display and the alarm is not reset.
The manoeuvre counter resets.
The number of hours
control unit, and the count is reset.
exceeded, the maintenance alarm is disabled
entirely.
At start of each manoeuvre, the control unit
acquires the position of MOTOR 1.
If the position is not read successfully, the
message is shown on the display.
At start of each manoeuvre, the control unit
acquires the position of MOTOR 2.
If the position is not read successfully, the
message is shown on the display.
and repeat
) and press
is displayed,
appears on
is stored by the
.
81