Changing Password - Roger Technology EDGE1/BOX Instrucciones Y Advertencias Para El Instalador

View manoeuvre hour counter
The number consists of the values of the parameters from
N.B.
When the manoeuvre hour limit (set by
1500 manoeuvre hours).
IMPORTANT
The message
To reset the alarm, release the protection by inputting the password (
is displayed, followed by the messages
until is displayed.
If the TEST key is released,
The number of hours
If the value =
Manoeuvre hours.
View control unit days on counter
The number consists of the values of the parameters from
N.B.
Days with unit switched on.
Password
Setting a password prevents unauthorised persons from accessing the settings.
With password protection active (
Only a single password is used to control access to the gate automation system.
WARNING: Contact the Technical Support Service if you lose your password.
Password activation procedure:
• Enter the desired values for parameters
• Use the UP
• Press and hold the
•
• Switch the control unit off and on again. Check that password protection is activated ( =
Temporary unlock procedure:
• Enter the password.
• Check that
Password cancellation procedure:
• Enter the password (
• Save the values
• Use the UP
• Press and hold the + and - buttons for 4 seconds.
•
indicate that no password is set).
• Switch the control unit off and on again (

Changing password

Protection deactivated.
Protection activated.
78
and
appears on the display and the alarm is not reset.
is stored by the control unit, and the count is reset.
= is exceeded (9990 hours of operation) the maintenance alarm is no longer managed.
= 123 hours.
= 123 days.
=
,
buttons to view the parameter
= .
= ).
, , , =
buttons to view the parameter
to .
) is exceeded, the visual maintenance signal is activated (e.g. every
to .
, and .
.
.
= ).
) and press TEST for 5 s. The message
).
, , and