Pit Boss Pro PB1100PSC2 Manual Del Usuario página 27

• SETTING UP A RECIPE
The Recipe function allows the user to program cooking instructions, known as Recipe Steps, for the Control Board to follow
and automatically run. These cooking instructions are a combination between Cooking temperature and Time. Starting from
the first Recipe Steps (01), the Control Board will cycle through each Recipe Steps to cook the meal. When all the Recipe Steps
are complete, the Control Board will automatically switch to a low temperature of 82°C / 180°F so that the meal stays warm
until ready to serve. There are a total of nine Recipe Steps available to be programmed.
HOW TO PROGRAM A RECIPE STEP
To set one or more of the Recipe Steps, follow the steps below:
1. Press and hold the Recipe Button. This will make the Recipe Button blink to show the Recipe settings are
active. This will also activate the Recipe Steps and the letter 'S' will be on to show it is active.
• Use the Controller Knob to select the Recipe Step. Start with the first Recipe Step (01).
• When desired Recipe Step is reached, press the Controller Knob to go to next setting.
2. Set the Time hours. The hours of the Time readout will blink, to show it is selected.
• Use the Controller Knob to select the hours desired.
• When desired hours are reached, press the Controller Knob to go to next setting.
3. Set the Time minutes. The minutes of the Time readout will blink, to show it is selected.
• Use the Controller Knob to select the minutes desired.
• When desired minutes are reached, press the Controller Knob to go to next setting.
4. Set the Temperature. The central temperature readout will blink, to show it is selected.
• Use the Controller Knob to select the desired temperature.
• When desired temperature is reached, press and hold the Recipe Button to lock in all Recipe settings
for that Recipe Step.
• To set another Recipe Step, quick press the Recipe Button to select another Recipe Step,
programming a multiple Recipe Step cook. Repeat steps above, as desired.
Or,
• Press and hold the Recipe Button a second time to exit the Recipe settings and run the Recipe.
The Recipe Button will stop blinking.
NOTE: The Recipe Steps will reset when the unit is shut-down / turned off.
27