Stihl FS 160 Manual De Instrucciones página 67

5 Mounting the Bike Handle
► Refit the front part of the support.
► Fit the seven mounting screws but do not
tighten them down yet.
► Position the support so that distance (B)
between it and the clutch housing (5) is about
24 cm.
► Now tighten down the seven mounting screws
on the support firmly.
0458-323-8721-D
B
5
3
5.2.2 Mounting the control handle
► Take out the screw (6) – the nut (7) remains in
the control handle (8).
► Push the control handle onto the handlebar (4)
until the holes (10) line up – the throttle trig‐
ger (9) must point towards the gearbox.
► Insert screw and tighten it down firmly.
English
67