Fuel; Mixing Fuel - Stihl FS 160 Manual De Instrucciones

English
WARNING
Collar (a) must locate in the cutting attachment's
mounting hole (b).
9.13.3 Securing the cutting attachment
► Fit the thrust washer (2) – convex side must
face up.
► Fit the rider plate (3) (for sawing applications).
► Block the shaft.
► Screw the mounting nut (4) on to the shaft
counterclockwise and tighten it down firmly.
WARNING
If the mounting nut has become too loose, fit a
new one.
NOTICE
Remove the tool used to block the shaft.
9.13.4 Removing the cutting attachment
► Block the shaft.
► Unscrew the mounting nut clockwise.
► Pull the cutting attachment with its mounting
hardware off the gearbox.

10 Fuel

The engine requires a mixture of gasoline and
engine oil.
WARNING
Avoid direct skin contact with fuel and breathing
in of gasoline fumes.
10.1 STIHL MotoMix
STIHL recommends using STIHL MotoMix. This
pre-blended fuel is free of benzene and lead, is
distinguished by a high octane rating, and
always provides the proper mixing ratio.
STIHL MotoMix uses STIHL HP Ultra two-stroke
engine oil for optimum engine life.
MotoMix is not available in all markets.
78
10.2

Mixing fuel

NOTICE
Unsuitable fuels or a mixing ratio that deviates
from the specification can lead to severe engine
damage. The engine, seals, fuel lines and fuel
tank may be damaged if low-quality gasoline or
engine oil is used.
10.2.1 Gasoline
Use only high-quality gasoline with an octane rat‐
ing of at least 90 ROC – leaded or unleaded.
Gasoline with an alcohol component exceeding
10% can cause impaired engine performance in
engines with manually adjustable carburetors
and thus should not be used in these engines.
Engines with M-Tronic deliver full engine per‐
formance using gasoline with an alcohol compo‐
nent of up to 27% (E27).
10.2.2 Engine oil
If you mix the fuel yourself, use only STIHL two-
stroke engine oil or another high-performance
engine oil classified as JASO FB, JASO FC,
JASO FD, ISO-L-EGB, ISO-L-EGC or ISO-L-
EGD.
STIHL specifies STIHL HP Ultra two-stroke
engine oil or an equivalent high-performance
engine oil in order to maintain emission limits
over the machine's service life.
10.2.3 Mixing ratio
with STIHL two-stroke engine oil 1:50; 1:50 =
1 part oil + 50 parts gasoline
10.2.4 Examples
Quantity of gaso‐ STIHL two-stroke
line engine oil 1:50
Liters Liters
1 0.02
5 0.10
10 0.20
15 0.30
20 0.40
25 0.50
► Pour oil into an approved safety fuel canister
first, then add gasoline and mix thoroughly
10.3 Storing fuel mixture
Store in approved safety fuel canisters only in a
dry, cool and secure place protected against light
and sunlight.
10 Fuel
(ml)
(20)
(100)
(200)
(300)
(400)
(500)
0458-323-8721-D