Descargar Imprimir esta página

Stihl Supercut; Stihl Autocut; Stihl Trimcut; Maintenance And Care - Stihl FS 160 Manual De Instrucciones

Ocultar thumbs Ver también para FS 160:

Publicidad

Idiomas disponibles

Idiomas disponibles

English
25.3
Adjusting Nylon Line

STIHL SuperCut

Fresh line is advanced automatically if the
remaining line is at least 6 cm (2 1/2 in) long.
The blade on the deflector trims overlong lines to
the correct length.

STIHL AutoCut

► With the engine running, hold the rotating
mowing head above the grass surface.
► Tap it on the ground once – fresh line is
advanced and the blade on the deflector trims
it to the right length.
Fresh line is advanced every time the mowing
head is tapped on the ground. For this reason
observe the mowing head's cutting performance
during operation. If the mowing head is tapped
on the ground too often, the line limiting blade
will unnecessarily cut off unused lengths of nylon
line.
Line feed operates only if both lines are still at
least 2.5 cm (1 in) long.

STIHL TrimCut

WARNING
To reduce the risk of injury, always shut off the
engine before adjusting the nylon line by hand.
► Pull the spool up – rotate it about 1/6 turn
counterclockwise until it engages – and allow it
to spring back.
► Pull ends of the lines outward.
Repeat the above procedure as necessary until
both lines reach the limiter blade on the deflec‐
tor.
Rotating the spool from one stop to the next
advances about 4 cm (1 1/2 in) of fresh line.

26 Maintenance and Care

The following intervals apply to normal operating
conditions only. If your daily working time is longer
or operating conditions are difficult (very dusty work
area, etc.), shorten the specified intervals accord‐
ingly.
Complete machine
92
Visual inspection (condi‐
tion, leaks)
25.4
Replacing Nylon Line

STIHL PolyCut

Precut lengths of nylon line can be fitted to the
PolyCut in place of the cutting blades.
STIHL DuroCut, STIHL PolyCut
WARNING
To reduce the risk of injury, always shut off the
engine before refilling the mowing head.
► Fit precut lengths of nylon line in the mowing
head as described in the instructions supplied.
25.5

Replacing Cutting Blades

25.5.1
STIHL PolyCut
Always check the mowing head for signs of wear
before installing new cutting blades.
WARNING
If there are signs of serious wear, replace the
complete mowing head.
The thermoplastic cutting blades are referred to
as "blades" in the following.
The mowing head is supplied with illustrated
instructions for replacing the blades. Keep the
instructions for the mowing head in a safe place.
WARNING
To reduce the risk of injury, always shut off the
engine before installing the blades.
► Remove the mowing head.
► Replace blades as shown in the illustrated
instructions.
► Mount the mowing head on the machine.
X
X
26 Maintenance and Care
0458-323-8721-D

Hide quick links:

Publicidad

Capítulos

loading

Este manual también es adecuado para:

Fs 220Fs 280Fs 290