Attaching The Special Nozzles - Dirt Devil AquaClean M317 Manual De Instrucciones

M317.book Seite 40 Montag, 30. September 2013 1:40 13
3 Preparing the appliance

3.4 Attaching the special nozzles

NOTE:
All special nozzles can only be fitted onto
the previously mounted pinpoint nozzle. All
special nozzles are attached in the same
way.
A
B
C
9
A
B
10
A
B
11
40
1. Fit the pinpoint nozzle as described,
2. If the cleaning effect of the jet of steam

move stubborn dirt from very hard-wearing
surfaces.

move stubborn dirt from scratch-resistant sur-
faces.

for removing dirt from between tiles and
90°
grooves.

ed if the jet of steam has to be very concen-
trated like for the pinpoint jet nozzle.

serves to scrape off dirt from scratch-resist-
ant, smooth surfaces.

serves to scrape off glass surfaces to which
steam had previously been applied. Observe
the instructions under Chapter 4.3, "Steam-
cleaning glass surfaces" for this.
90°

with cotton cover serves to freshen up up-
holstery and clothes. Observe the instructions
under Chapter 4.4, "Refreshing upholstery
and clothing" for this.
3. Slide the respective special nozzle onto
4. Fasten the respective special nozzle by
NOTE:
90°
By turning is in the opposite direction you
can release the respective special nozzle
again.
Chapter 3.3, "Attaching the pinpoint
nozzle".
alone is not sufficient for your cleaning
task, select a special nozzle.
The wire brush (Fig. 9/A) serves to re-
The plastic brush (Fig. 9/B) serves to re-
The crevice brush (Fig. 9/C) works best
The jet nozzle (Fig. 10/A) is recommend-
The spatula attachment (Fig. 10/B)
The 2-in-1 combi attachment (Fig. 11/A)
The 2-in-1 combi attachment (Fig. 11/B)
the pinpoint jet nozzle.
turning it 90° in the direction of the arrow.