Steam Cleaning Using Disinfectant - Dirt Devil AquaClean M317 Manual De Instrucciones

M317.book Seite 46 Montag, 30. September 2013 1:40 13
4 Use
WARNING:
Danger of scalding when interrupting work!
Pull the plug from the socket if you inter-

rupt work, e.g. to change attachments.
 Wait at least ten minutes before remov-
ing the fitted attachments.

4.2 Steam cleaning using disinfectant

max
20
min
21
22
46
NOTE:
You can also regulate steam power and
cleaning effect by adjusting the distance to
the surface to be cleaned.
1. Check that the disinfectant tank is full. If
2. Turn the disinfectant regulator on the han-
NOTE:
Make sure that the controller clicks into the
position chosen. Positions between the
three marked positions are pointless and
obstruct problem-free function.
3. Insert the plug into a mains socket with a
NOTE:
off
Disinfectant will be added to the jet of
steam until the disinfectant tank is empty or
you turn the regulator for the addition of dis-
infectant back to
(Fig. 22).
not, fill it (Chapter 3.6, "Filling the disin-
fectant tank").
dle according to whether you want to add
a lot of disinfectant to the jet of steam or
just a little:
- for a lot of disinfectant in the jet of
steam: 'MAX' position (Fig. 20).
- for a small quantity of disinfectant in the
jet of steam: 'MIN' position (Fig. 21).
ground/safety contact and proceed as de-
scribed in Chapter 4.1, "Steam clean-
ing" .
the 'OFF' position