Husqvarna WR 250 2012 Caracteristicas - Uso - Mantenimiento página 102

FLUID CHANGE
The brake fluid should be checked and changed in accordance
with the Periodic Maintenance Chart or whenever it is contami-
nated with dirt or water. Don't change the fluid in the rain or
when a strong wind is blowing.
1A
EN - 44
MUM2_WR250-300_2012_GB.indd 44
CAUTION!
* Use only brake fluid from a sealed con-
tainer (DOT 4). Never use old brake fluid.
* Never allow contaminants (dirt, water,
etc.) to enter the brake fluid reservoir.
* Don't leave the reservoir cap off any
length of time to avoid moisture contami-
nation of the fluid.
* Handle brake fluid with care because it can
damage paint.
* Don't mix two types of fluid for use in the
brake. This lowers the brake fluid boil-
ing point and could cause the brake to be
ineffective. It may also cause the rubber
brake part to deteriorate.
1
To replace the fluid, proceed as follows:
- Remove the rubber cap on the bleeding valve (1) or (1A).
- Attach a clear plastic hose to the bleeding valve on the brake
caliper and turn the other end of the hose into a container.
- Remove fluid reservoir cap (2) or (2A) and the rubber.
- Loosen bleeding valve on the brake caliper.
2A
9-05-2011 18:03:03