Husqvarna WR 250 2012 Caracteristicas - Uso - Mantenimiento página 88

HANDLEBAR POSITION AND HEIGHT CHANGE
The handlebar position (a) and height (b) can be changed for
better suiting Your driving requirements. To effect these opera-
tions, remove the upper clamp (1) and the lower one (2), after
removing the fixing srews (3) and (4).
A
EN - 30
MUM1_WR250-300_2012_GB.indd 30
a) Handlebar position change
Turn the lower clamp (2) 180° to move forward or backward
(10mm- 0.04in.) the handlebar position with respect to the
original setup.
4
1
3
2
b) Handlebar height change
Remove the lower spacer (A) then replace the screw (4) with a
new one of L=65 mm (2.56 in.) height.
Once these operations are completed, tighten the screws (3) to
2,75-3,05 kgm (27-30 Nm; 19.9-22 Lb/fts) and the screws (4)
to 2,0-2,2 kgm (19,6-21,6 Nm; 14.5-15.9 Lb/fts
1
3
2
A
9-05-2011 16:52:31