Husqvarna WR 250 2012 Caracteristicas - Uso - Mantenimiento página 72

HANDLEBAR COMMUTATOR
1) Engine stop button ( )
2) HI = ( ) Selection control High beam
LO = ( ) Selection control of Low beam
3) TURN
= Activation of left turn indicators (self cancelling)
= Activation of right turn indicators (self cancelling)
To deactivate the indicator, press the control lever after
its returning to center.
4) HORN = ( ) Warning horn
5) LIGHTS
= Lighting control of lowbeams and high beam.
= Lighting control of position lights.
= Off
EN - 14
MUM1_WR250-300_2012_GB.indd 14
CLUTCH CONTROL
The clutch lever is located on the left-hand side of the handlebar
and is protected against dirt filtering in. The lever support is
provided with adjusting screw (1) to regulate clutch wire free
play (see on page 22). The clutch
lever can be adjusted to suit your driving position.
CAUTION
Do not forget to tighten the screws (C) after
the adjustment.
A: To decrease clearance
B: To increase clearance
REAR BRAKE CONTROL
The rear brake control (1) is placed on the right-hand side of the
motorcycle. On models TE and SMR as stop switch, during the
braking action, causes the rear light to come on.
1
9-05-2011 16:52:22