Pioneer PDP-6010FD Manual De Instrucciones página 20

Preparation
05
2 Fit the speaker to the mounting fittings in the correct direction.
• Be sure not to mount the speaker upside down.
For illustrative purposes, the table
top stand is not presented here.
Caution
• To avoid any damage to the speaker and/or table top stand from striking against each other, fit the speaker to the mounting fittings
while confirming their locations. As you may easily strike the stand, use the protective wrapping in which the speaker was wrapped
between the speaker and stand.
• When the speaker mounting fittings do not fit the grooves at the rear of the speaker, adjust the speaker mounting fittings angle.
3 Fix the speaker mounting fittings and the speaker with the supplied screws.
• Fix the center part of the speaker first with the supplied screws, then fix the right and left sides alike.
• Tighten the four screws in the order
7
8
4
2
Speaker
mounting screw
(M5 x 10 mm)
4 Tighten the four screws in the above drawing
snugly.
20
En
Insert the speaker mounting
fittings into the grooves at the
rear of the speaker.
, , , as shown in the drawing.
1
3
Screw hole
The side with the padding strip is
facing upwards.
Caution
• If you want to move the plasma display unit,
make sure that you remove the speaker first.
In addition, do not move the display holding
on to the mounting fittings. This can result in
5
injury or damage to the unit.
6
The screw hole at the bottom surface of the
speaker mounting fitting is used when the
plasma display is installed on the wall. It is not
used when installed with the stand.
Note
• If after attaching the speaker its position
needs to be adjusted horizontally or
vertically, first loosen the speaker mounting
screws, reposition and then tighten the
, , ,
screws again at the appropriate position.
Protective
wrapping
Front side of
the speaker