Pioneer PDP-6010FD Manual De Instrucciones página 29

Preparation
2
With the plasma display lying flat, fit the stand's
support columns to the bottom of the plasma display as
indicated by the arrows, then slowly insert them.
• Be extremely careful not to insert the support columns of
the stand into any part of the plasma display other than the
stand insertion slots. Doing so might damage the plasma
display panel or its ports or result in warping of the stand.
Insert the stand into
the plasma display so that
an arrow with "FRONT/FACE AVANT" mark inscribed
at the bottom of the stand indicates downward.
Plasma
display
Insert the stand into the plasma display so that an arrow with "FRONT/FACE
AVANT" mark inscribed at the bottom of the stand indicates downward.
(PDP-6010FD)
Line up the column supports
with the bottom of the plasma
display, as indicated in the
accompanying diagram.
(PDP-5010FD)
3
Attach the stand at the points indicated by the arrows
and tighten the installation bolts (2) and (1) firmly using
a screwdriver.
Installation bolt (1): M8 x 23 mm (black) for PDP-5010FD
M6 x 20 mm (black) for PDP-6010FD
Installation bolt (2): M8 x 40 mm (black) for PDP-5010FD
M6 x 20 mm (black) for PDP-6010FD
Installation bolts (1) (Step 1)
Installation bolts (2)
(Step 2)
(PDP-6010FD)
Screw hole with "T" inscribed
(PDP-5010FD)
4
Replace the plasma display to stand upright.
For speaker installation, see "Installing the Pioneer
speaker" on page 18.
Note
• Be sure to install the plasma display in a flat, stable location.
• Insert the screws into the holes vertically and tighten them.
• Place a sheet or protective cover to protect the display from
scratches or damage.
• Work only with the plasma display lying flat on a table or similar
surface.
• When lying the plasma display down, be careful not to scratch
or damage it.
Installation bolts (1) (Step 2)
Installation bolts (2) (Step 1)
05
29
En