Pioneer PDP-6010FD Manual De Instrucciones página 25

Preparation
4 Connect the supplied speaker cables to the rear of
plasma display.
Connect the cables correctly with respect to the polarity of
the plasma display speaker terminals, that is,  cable (Gray)
to  terminals (Red) and  cable (Black) to  terminals
(Black).
Gray
Note
• Press the lever and insert the end of the cable.
• When you release the lever, it clamps
onto the speaker cable.·
Caution
• Be sure to turn the connected devices off and remove the
power cord from the wall outlet beforehand when changing the
connection or installation method.
• If you insert the speaker cable too
far so that the insulation is
touching the speaker terminal, you
may not get any sound. Please
insert it with showing the copper
wire.
• Check if the end of the speaker cables are securely connected
to the terminals by slightly tugging on the cable after making
connections. Loose connections may result in sound dropouts
or noise.
• If there is a short in the  and  cables caused by an exposed
lead wire, excessive load may be applied to the plasma display,
resulting in interrupted operation or malfunction.
• Incorrect connections of the speaker cable to the right or left of
the plasma display terminals with respect to the polarity may
result in insufficient stereo sound effects, delivering poor bass
sounds or unstable sound image.
• Bundle the cable without pulling.
Black
Gray
Red
Black
Red
Speaker terminal
Speaker terminal
Lever
5 Connect the other end of the speaker cables to the
speaker.
Connect the cables correctly with respect to the polarity of
the speaker terminals, that is,  cable (Gray) to  terminals
(Red) and  cable (Black) to  terminals (Black).
Speaker cable
Speaker terminal
6 Bundle the cables.
• Bead bands are included with the plasma display.
• Use the bead bands as necessary.
• When tidying up your speaker cables, make sure to bundle
them so that they are not subjected to any pressure.
Rear view
Black Gray
Black Red
Bead band Speaker cable
05
25
En