Preparation
05
Detaching the Pioneer stand
• When removing the stand before you install the speaker,
begin with step 2.
• Besides the speaker, steps for detaching the stand are the
same for PDP-6010FD and PDP-5010FD.
1
Detach the supplied speaker if it has already been
installed.
• To detach the speaker, remove the cable wiring for the
speaker at the rear and screws at the rear of the speaker
and pull it out (see step 3 on page 20 for PDP-6010FD or
steps 3 on page 24 for PDP-5010FD).
• Use the protective sheet in which the speaker was
wrapped between the speaker and stand.
• Make sure to remove the speaker mounting fittings.
2
With the plasma display lying flat, loosen and remove
the two installation bolts (1) and (2) using a
screwdriver.
Installation bolt (1): M8 x 23 mm (black) for PDP-5010FD
Installation bolt (2): M8 x 40 mm (black) for PDP-5010FD
Installation bolts (1) (Step 1)
(PDP-6010FD)
28
En
M6 x 20 mm (black) for PDP-6010FD
M6 x 20 mm (black) for PDP-6010FD
Installation bolts (2)
(Step 2)
(PDP-5010FD)
3
Remove the stand from the plasma display.
Note
• Make sure to keep the installation bolts (1) and (2) that have
been removed as they are re-used when attaching the stand to
the plasma display.
• Place a sheet or protective cover to protect the display from
scratches or damage.
• Work only with the plasma display lying flat on a table or similar
surface.
• When lying the plasma display down, be careful not to scratch
or damage it.
Attaching the stand again
• When the plasma display is mounted without the supplied
speaker, begin with step 2.
• Besides the speaker, steps for attaching the stand are the
same for PDP-6010FD and PDP-5010FD (use the screw
holes with "T" inscribed).
1
Detach the supplied speaker when the plasma display is
being mounted on the wall, with the speaker attached.
• To detach the speaker, remove the cable wiring for the
speaker at the rear and screws at the bottom of the
speaker and pull it out (see illustrations on page 22 for
PDP-6010FD and on page 26 for PDP-5010FD).
Installation bolts (1) (Step 1)
Installation bolts (2) (Step 2)