Installing The Pioneer Speaker - Pioneer PDP-6010FD Manual De Instrucciones

Preparation
05
Note
• Assemble the stand with a soft sheet placed under the base
cover. If a sheet is not laid before assembly, the front surface of
the base cover may be scratched.
• Please take care when installing stand pipes (L) and (R) to
ensure that they are in the correct positions. Mistakenly
installing the stand pipes may damage the stand.
Attaching the stand
• When the plasma display is mounted without the supplied
speaker, begin with step 2.
• Besides the speaker, steps for attaching the stand are the
same for PDP-6010FD and PDP-5010FD (use the screw
holes with "T" inscribed).
1
Detach the supplied speaker when the plasma display is
being mounted on the wall, with the speaker attached.
• To detach the speaker, remove the cable wiring for the
speaker at the rear and screws at the bottom of the
speaker and pull it out (see illustrations on page 22 for
PDP-6010FD and on page 26 for PDP-5010FD).
2
With the plasma display lying flat, fit the stand's
support columns to the bottom of the plasma display as
indicated by the arrows, then slowly insert them.
• Be extremely careful not to insert the support columns of
the stand into any part of the plasma display other than the
stand insertion slots. Doing so might damage the plasma
display panel or its ports or result in warping of the stand.
Insert the stand into
the plasma display so that
an arrow with "FRONT/FACE AVANT" mark inscribed
at the bottom of the stand indicates downward.
18
En
3
Attach the stand at the points indicated by the arrows
and tighten the installation bolts (2) and (1) firmly using
a screwdriver.
Installation bolt (1): M8 x 23 mm (black) for PDP-5010FD
Installation bolt (2): M8 x 40 mm (black) for PDP-5010FD
Installation bolts (1) (Step 1)
(PDP-6010FD)
4
Replace the plasma display to stand upright.
For speaker installation, see "Installing the Pioneer
speaker".
Note
• Be sure to install the plasma display in a flat, stable location.
• Insert the screws into the holes vertically and tighten them.
• Place a sheet or protective cover to protect the display from
scratches or damage.
• Work only with the plasma display lying flat on a table or similar
surface.
• When lying the plasma display down, be careful not to scratch
or damage it.

Installing the Pioneer speaker

Caution
• If you want to move the plasma display unit, make sure that you
remove the speaker first. In addition, do not move the display
holding on to the mounting fittings. This can result in injury or
damage to the unit.
About the speaker
• In order to prevent damage to the speaker system resulting
from input overload, please observe the following precautions:
• Do not use the speaker with anything other than the plasma
display. Doing so may result in damage or fire.
• Be sure to turn the connected devices off and remove the
power cord from the power outlet beforehand when changing
the connection or installation method.
• When using a tone control function to greatly emphasize treble
sounds, do not use excessive amplifier volume.
• Please handle the speaker with sufficient care, as the grille net
and the cabinet can become damaged or broken when they are
(PDP-6010FD)
subjected to strong external impacts.
• Placing a CRT computer screen or CRT monitor near to the
speaker may result in interference or color distortion. If this
happens, distance the monitor from the speaker.
M6 x 20 mm (black) for PDP-6010FD
M6 x 20 mm (black) for PDP-6010FD
Installation bolts (2)
(Step 2)