FD2200 4WD/ Translation of the original instructions
28)Do not tamper with the safety devices or disable them.
29)Do not change the engine settings, especially the maximum number of revs.
30)Do not rest heavy loads on the seat, the starter safety device could become disengaged.
31)Never attempt any adjustments or cleaning with the engine running.
32)Never allow anyone to check the machine while you are seated at the controls with the engine running.
33)Do not move the machine without the deck, wheelies may result and be very dangerous.
34)Do not lift the grass catcher when the machine is moving.
35)Replace worn or damaged exhaust boxes.
FURTHER SAFETY ADVICE
The above-mentioned warnings could not be enough to avoid any risk, if the operator does not use the
present lawnmower correctly. Therefore for your safety we give following advices:
36)The mower blade is very dangerous when rotating, never put hands or feet underneath the mower deck.
37)Do not drive in reverse at high speed.
38)It is dangerous to operate the steering wheel abruptly with the motor at full power.
39)Fill the tank with fuel before starting the engine. Only refuel outdoors, always turn off the engine, keep
away from sparks or naked flames, do not smoke! Always replace the cap on the fuel tank and those on fuel
containers properly.
40)Drain the fuel tanks outdoors only, if necessary.
41)Do not operate the mower over gravel which could be sucked up and thrown away by the blade,
becoming very dangerous.
42)If you have children, hide the ignition key after using the machine.
43)CAUTION: to avoid the risk of fire, keep the engine compartment, exhaust box, discharge outlets, battery,
tank area and fuel pipes free of grass, leaves, dirt, etc.
44)Do not store the machine inside any building where the engine fumes can reach naked flames, sparks or
bare electrical wires.
Remove the implements and turn off the engine:
a) before cleaning obstructed points.
b) before checking or repairing the lawnmower.
c) when the machine hits a foreign body (check the mower deck to see if it is damaged. Make repairs
before you operate).
d) if abnormal vibration occurs, stop and inspect the machine. Contact the nearest authorized
service centre if you need help.
6