WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS L
Are these the right instructions for your model? Follow the Installation Instructions indicated by
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
WARNING
To eliminate the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow these
instructions can result in electrical shock.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1/4" and 5/16" Nutdrivers
REMOVE THE COVER
1
At the bottom rear of the refrigerator, remove the
screw(s) holding the access cover.
Bend the cover back for access to the compartment.
Be sure to save the screws as the access cover must
be reinstalled later to ensure your refrigerator will
function properly.
Installation Instructions
L M N Q R S T U V
Pliers
Sharp knife
ATTACH THE WATER VALVE
2
• Locate the female connector plug (C) which is
attached to the cabinet by a metal or plastic clip.
Remove the clip by removing the screw.
• Plug the female connector (C) onto the male
terminals on the water valve (4). Either wire
can go on either terminal.
• Fasten the water valve to the cabinet by driving the
hex-head screw (15) from the kit into the hole
in the cabinet leg.
12
or
W
Metal or
plastic clip
C
4
C
15