GE IM-6D Manual Del Propietario E Instalación página 19

ICEMAKER INSTALLATION INSTRUCTIONS N
Are these the right instructions for your model? Follow the Installation Instructions indicated by
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
WARNING
To eliminate the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow these
instructions can result in electrical shock.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
REMOVE ICE CUBE TRAY SHELF
1
• Remove the two screws securing the ice cube tray
to the side wall of the freezer. Remove the tray.
• There are two white plug buttons above the screw
holes. Remove these plug buttons and install them
in the two screw holes that were used to hold the
ice cube tray shelf.
• Install two Phillips head screws (16) in the holes
that the plug buttons were in, but do not screw
them all the way in. The screw heads should
of the freezer.
Plug
Buttons
Installation Instructions
Pliers Sharp knife
16
L M N Q R S T U V
PREPARE FOR INSTALLATION
2
• Remove and discard the large white plug from the
rear freezer wall. Pull out the gray insulation plug
and remove any debris.
• Remove the outlet cover with a flat-blade
screwdriver.
INSTALL FILL TUBE
3
• Cut the fill tube with foil (19) to the
(refer to the
knife or a single-edge razor blade.
• Slide the fill tube with foil (19)
onto the water tube inlet
• Go to the back of the refrigerator.
On the tube side of the water
tube inlet
adhesive backing. Remove the
adhesive backing and slide the
tube into the hole near the top
at the back of the refrigerator.
Firmly press on the inlet to
secure it to the refrigerator.
SET POWER SWITCH TO OFF
4
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
18
or
W
N
template on page 47) with a sharp
N
(Appearance may vary)
length
19