GE IM-6D Manual Del Propietario E Instalación página 21

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS N
Are these the right instructions for your model? Follow the Installation Instructions indicated by
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
WARNING
To eliminate the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow these
instructions can result in electrical shock.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1/4" and 5/16" Nutdrivers
REMOVE THE COVER
1
Use a 5/16" nutdriver or an adjustable wrench to
remove the compressor compartment access cover.
cover to the back of the refrigerator case.
Be sure to save the screws as the access cover
must be reinstalled later to ensure your refrigerator
will function properly.
Installation Instructions
L M N Q R S
Sharp knife
Pliers
or
T U V
ATTACH THE BRACKET EXTENSION
2
TO THE WATER VALVE
22
• While leaving a loop of about 2" below the valve,
snap the water line into the clip on the side of the
water valve.
ATTACH THE WATER VALVE TO THE
3
MACHINE COMPARTMENT
• Locate the female connector plug. Plug the female
connector onto the male terminals on the water
valve. Either wire can go on either terminal.
• Fasten the water valve (4) to the cabinet by driving
in the cabinet.
15
22
W
About 2"
23
4