GE IM-6D Manual Del Propietario E Instalación página 23

ICEMAKER INSTALLATION INSTRUCTIONS Q
Are these the right instructions for your model? Follow the Installation Instructions indicated by
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
WARNING
To eliminate the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow these
instructions can result in electrical shock.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
PREPARE FOR INSTALLATION
1
• Remove and discard the large white plug or foil
sticker from the rear freezer wall. Pull out the
gray insulation plug and remove any debris.
• Loosen the two mounting screws but do not
screw them all the way out. The screws should
the freezer wall.
• Remove the outlet cover with a flat-blade
screwdriver.
Installation Instructions
L M N Q R S
Pliers Sharp knife
T U V
INSTALL FILL TUBE
2
• Cut the fill tube (19) to the
length (refer to the
on page 47) with a sharp knife
or a single-edge razor blade.
• Slide the fill tube (19) onto the
water tube inlet
• Go to the back of the refrigerator. In the upper
right hand corner, remove the label covering the
hole. Pull out the insulation plug and any debris.
• On the tube side of the
water tube inlet
is an adhesive backing.
Remove the adhesive
backing and slide the tube
into the hole near the top at
the back of the refrigerator. Firmly press on the
inlet to secure it to the refrigerator.
SET POWER SWITCH TO OFF
3
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
22
or
W
Q
template
Q
(Appearance may vary)
19