GE IM-6D Manual Del Propietario E Instalación página 33

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS S
Are these the right instructions for your model? Follow the Installation Instructions indicated by
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
WARNING
To eliminate the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow these
instructions can result in electrical shock.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1/4" and 5/16" Nutdrivers
REMOVE THE COVER
1
At the bottom rear of the refrigerator, remove the
screws holding the access cover.
Bend the cover back to access the compartment.
Be sure to save the screws as the access cover
must be reinstalled later to ensure that your
refrigerator will function properly.
CUT PLASTIC WATER TUBING
2
Measure 25" (64 cm) of water tubing starting from
tubing with a sharp knife or single-edge razor blade.
Installation Instructions
L M N Q R S
Sharp knife
Pliers
Tape measure
25" (64 cm)
or
T U V
ATTACH THE WATER VALVE
3
• Locate the female connector plug (C).
• Slide the water valve shield with ground wire shipped
with the refrigerator completely onto the water valve.
NOTE:
has been misplaced and/or the ground wire (part
• Plug the female connector (C) onto the male
terminals on the water valve (4). Either wire
can go on either terminal.
• Fasten the water valve to the cabinet by driving
the hex-head screw
in the cabinet leg.
Water valve
bracket
W
C
4
C
Cabinet
13