What You Will Need - GE IM-6D Manual Del Propietario E Instalación

BEFORE YOU BEGIN
Recommended copper water supply kits are WX8X2,
tubing you need. Approved plastic water supply
lines are SmartConnect
™
When connecting your refrigerator to a GE Appliances
Reverse Osmosis Water System, the only approved
installation is with a GE Appliances RVKit. For
other reverse osmosis water systems, follow the
manufacturer's recommendations.
If the water supply to the refrigerator is from a Reverse
Osmosis Water Filtration System AND the refrigerator
also has a water filter, use the refrigerator's filter bypass
plug. Using the refrigerator's water filtration cartridge
in conjunction with the RO filter can result in hollow ice
cubes and slower water flow from the water dispenser.
This water line installation is not warranted by the
refrigerator or icemaker manufacturer. Follow these
water damage.
Water hammer (water banging in the pipes) in
house plumbing can cause damage to refrigerator
parts and lead to water leakage or flooding. Call a
qualified plumber to correct water hammer before
installing the water supply line to the refrigerator.
To prevent burns and product damage, do not hook
up the water line to the hot water line.
If you use your refrigerator before connecting
the water line, make sure the icemaker power switch
is in the OFF position.
Do not install the icemaker tubing in areas where
temperatures fall below freezing.
When using any electrical device (such as a power
drill) during installation, be sure the device is double
insulated or grounded in a manner to prevent the
hazard of electric shock, or is battery powered.
All installations must be in accordance with local
plumbing code requirements.
WARNING
Connect to potable water
supply only.
Installation Instructions
INSTALLING THE WATER LINE
Refrigerator Tubing

WHAT YOU WILL NEED

• Copper or SmartConnect
1/4" outer diameter to connect the refrigerator to
the water supply. If using copper, be sure both ends
of the tubing are cut square.
To determine how much tubing you need: measure
the distance from the water valve on the back of the
refrigerator to the water supply pipe. Then add 8 feet
diameter) to allow the refrigerator to move out from
the wall after installation.
SmartConnect Refrigerator Tubing Kits are available
™
in the following lengths:
2'
8'
15' (4.6
Be sure that the kit you select allows at least 8 feet
(2.4 m) as described above.
NOTE: The only GE Appliances approved plastic
tubing is that supplied in SmartConnect
Refrigerator Tubing kits. Do not use any other
plastic water supply line because the line is under
pressure at all times. Certain types of plastic will
crack or rupture with age and cause water damage
to your home.
• A GE Appliances water supply kit (containing
tubing, shutoff valve and fittings listed below) is
• A cold water supply. The water pressure must be
• Power drill.
• 1/2" or adjustable wrench.
• Straight and Phillips blade screwdriver.
Refrigerator Tubing kit,
™
™