GE IM-6D Manual Del Propietario E Instalación página 25

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS Q
Are these the right instructions for your model? Follow the Installation Instructions indicated by
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
WARNING
To eliminate the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow these
instructions can result in electrical shock.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1/4" and 5/16" Nutdrivers
REMOVE THE COVER
1
Use a 5/16" nutdriver or an adjustable wrench to
remove the compressor compartment access cover.
cover to the back of the refrigerator case.
Be sure to save the screws as the access cover
must be reinstalled later to ensure your refrigerator
will function properly.
Installation Instructions
L M N Q R S T U V
Sharp knife
Pliers
ATTACH THE WATER VALVE
2
Locate the female connector plug (C). Plug the
female connector (C) onto the male terminals on the
water valve (4). Either wire can go on either terminal.
• Fasten the water valve to the cabinet edge hole
with the hex-head screw (15) from the kit.
DO NOT DRILL ANY ADDITIONAL HOLES.
• Check the plastic water line nut on the bottom
of the water valve to be sure it is hand tight.
DO NOT USE TOOLS.
INSTALL WATER LINE CLAMP
3
Attach the water line clamp (strain relief) (17) from
•
the kit to the refrigerator. With the clamp directly
in line with the water valve, drive the screw (7)
from the kit through the clamp (17) at the indent
into the back of the cabinet.
The metal clamp is for the house water line (see
•
Water Line Installation Instructions). It is not to be
used for the tubing from the water valve up to the
icemaker.
24
or
W
4
C
15
7
17