GE IM-6D Manual Del Propietario E Instalación página 15

ICEMAKER INSTALLATION INSTRUCTIONS M
Are these the right instructions for your model? Follow the Installation Instructions indicated by
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
WARNING
To eliminate the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow these
instructions can result in electrical shock.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
REMOVE THE OUTLET COVER
1
Remove the outlet cover
with a flat-blade
screwdriver.
PREPARE FOR INSTALLATION
2
Inside the freezer, loosen the two mounting screws
(B) but do not screw them all the way out. If your
model does not have the screws already in the
freezer wall, look for two plug buttons. Remove the
plug buttons and insert the two Phillips head screws
B
Installation Instructions
L M N Q R S
Pliers Sharp knife
T U V
INSTALL FILL TUBE
3
• If the refrigerator already has a water tube inlet
on the back of the refrigerator, use a flat-blade
screwdriver to gently remove it. The removed
plastic elbow and gasket can be
discarded.
• Remove and discard the white plug
from the upper left corner of the
freezer wall.
• Open the fresh food door and
locate the label in the upper left corner of the
compartment.
• Find the model number in bold listed under MODEL
NO.
• Match the two digit number in the model number
to the table below. NOTE: The desired number
starts at the fourth character.
Model Number
GENERAL ELECTRIC COMPANY
APPLIANCE PARK LOUISVILLE, KY 40225
MODEL NO.
www.GEAppliances.com
GTH18GBDCRWW
LISTED HOSEHOLD REFRIGERATOR/FREEZER
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
• Go to the back of the refrigerator. Find the small
label in the upper right hand corner and peel it off.
There is an adhesive backing on the fill tube (11 or
12). Remove the adhesive backing and slide the
tube into the hole near the top at the back of the
refrigerator. Firmly press on the inlet to secure it to
the refrigerator.
14
or
W
Model
Number
SERIAL NO.
16
FZ743041
182A
17
IIIIIIIIIII
IIIIIIII
18
IIIIII
11 or 12
Remove
plug
Fill
Tube
#
11
#
11
#
12