Coded Error Messages - Kärcher MC 130 Manual Del Usuario

Ocultar thumbs Ver también para MC 130:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 280
Malfunction
The following coded error messages can occur when operating
the level V engines V2403-CR-TE4B-KRC-1 (MC 130 plus, MC
130 classic).
When an error is indicated while the engine is running, the indi-
cator lamp flashes and an error code may also be shown on the
display.
NCD error
Indicator lamp blinks
U0076
1Hz (one second interval) + on for 5 seconds +
1 Hz (one second interval) + on for 5 seconds ...
Malfunction
U0076
P0102
P03014 / P1A28
P3015
P2455
108
Cause
Hydraulic oil temperature too high.
Hydraulic oil temperature too low.
Engine oil pressure is too high.
Parking brake active.
Low fuel level.
Battery is not charging.
Regeneration process required.
Service required.

Coded error messages

Cause
No communication with the exhaust gas
return
Air mass sensor abnormal
Fault in the DPF system
No DPF function
Differential sensor abnormal
Remedy
 Operate the engine in idling mixture until the warning
light goes out.
 Carefully warm up the engine until the warning light
goes out.
 Call Customer Service.
 Release the parking brake.
 Top up the fuel.
 Vent the fuel system if the tank was run dry.
 Call Customer Service.
 Perform regeneration, see Start regeneration.
 Have the device serviced by Customer Service.
a The service display must be reset by Customer Ser-
vice.
NCD error
Indicator lamp blinks
P0102
1Hz + on for 5 seconds + 1 Hz + on for 5 sec-
onds ...
PCD Error
Indicator lamp blinks
P3014
1 Hz (1 second interval)
P1A28
1 Hz (1 second interval)
P3015
1 Hz (1 second interval)
P2455
1 Hz (1 second interval)
Remedy
 Engine loses power and the exhaust emission perfor-
mance becomes worse
a Contact Customer Service
 Engine loses power and the exhaust emission perfor-
mance becomes worse
a Contact Customer Service
 Engine loses power and the exhaust emission perfor-
mance becomes worse
a Contact Customer Service
 Engine loses power and the exhaust emission perfor-
mance becomes worse
a Contact Customer Service
 No change in behaviour
a Contact Customer Service
English

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mc 130 advancedMc 130 plus1.442-230.21.442-233.2

Tabla de contenido