2-Brush Sweeping System Attachment Kit (Pulled); Installing The Sweeping System; View Of The Device For A 2-Brush Sweeping System; Connecting The High-Pressure Hoses And Water Hoses - Kärcher MC 130 Manual Del Usuario

Removing the front power lift
1. Raise the front power lift to the end position.
2. Release the hydraulic hoses.
3. Unlock the front power lift (lever upwards).
Holder for supporting the front power lift
1
Front power lift frame
2
4. Use a lift truck to move the changing carriage under the front
power lift.
The holder for supporting the front power lift must sit in the
frame of the front power lift when the lift truck is raised.
5. Move the front power lift out using the lift truck.
6. Set the front power lift down in a safe place and move the lift
truck out.
2-brush sweeping system attachment kit

Installing the sweeping system

The pallet on which the sweeper system is delivered is also used
as a mounting aid for attachment/removal.
Pallet
1
2-brush sweeping system
2
Suction mouth installed
3
Locking lever in the upper position (open)
4
Holder on the vehicle
5
1. Move the lift truck under the pallet with the positioned sweeper
system.
2. Pull the locking lever upwards.
3. Move the sweeper system into the holder on the vehicle and
position it approximately 10 cm in front of the vehicle.
4. Connect the hydraulic hoses, paying attention to the colour
coding.
The connection assignments are described in a later chapter
5. Connect the water hoses.
6. Insert the device detection connector at the vehicle.
7. Insert the sweeper system into the vehicle mounting bracket,
all the way to the end stop.
8. Lock the sweeper system by pressing the locking lever down
(using the curved rod).
90
(pulled)
9. The locking mechanism must be adjusted correctly via the ad-
justing nuts when the system is attached for the first time or
transferred to another vehicle. When correctly adjusted, the
locking mechanism must engage when pressed down beyond
the dead point.
10.Attach the side brushes.

View of the device for a 2-brush sweeping system

2-brush sweeping system
1
Locking lever
2
Device detection plug
3
Hydraulic connection and water connection
4
Side brushes
5
1. Operation of the 2-brush sweeper system is described in a lat-
er chapter.

Connecting the high-pressure hoses and water hoses

Brush PTO
1
Pivot suction mouth/sweeping brush
2
Raise/lower sweeping brush
3
Brush PTO
4
Right-hand water connection
5
Left-hand water connection
6
1. Plug in the hydraulic hoses according to the colour coding.
2. Plug in the water hoses at the left and right sides.
English