Care Work; Adjusting The Sweeping Area - Kärcher MC 130 Manual Del Usuario

Using the weed brush
The front brush must be secured in the desired position when us-
ing the device as a weed brush.
Three positions are possible.
Travel direction
1
Right position
2
Front position
3
Left position
4
1. Secure the desired working position with bolts and spring pins.
See chapter Transport lock.
2. Press the Change of rotation direction button when working in
the Left position.
Transport lock
The front brush must be secured when driving on public roads
(transport journeys).
Bolt
1
Spring pin
2
1. Move the front brush carriage all the way to the left.
2. Secure the front brush in the corresponding position using a
pin and spring pin.
1 The existing lubrication points (grease nipples) are labelled.
Lubricate daily with multi-purpose grease.
2 Check the front brush and sweeping brush for tangled cords
and straps and remove as necessary.
3 Care for the chain as necessary, using a commonly available
chain spray.
4 Keep the hydraulic connections clean and check for leaks
once a week.
5 Check the front brush and sweeping brush for wear and tear
and replace if necessary.
94

Care work

Adjusting the sweeping area

1. Adjust the sweeping area as shown in the illustration.
Right: 9 am- 2 pm
Right-hand side: 10 am- 3 pm
Adjusting the side inclination
Screw 1
1
Screw 2
2
2. Unscrew the screws.
3. Adjust the side inclination via the rotation point of screw 1.
4. Tighten the screws.
Adjusting the head inclination forwards
Lock nut
1
Hexagon
2
5. Unscrew the counternut.
6. Adjusting the head inclination via the hexagon.
7. Tighten the counternut.
Adjusting the brush contact pressure
8. The brush system has a hydraulic brush contact pressure ad-
justment system.
English