Error Messages For Symbol Displays - Kärcher MC 130 Classic Manual Del Usuario

Malfunction
Dust when sweeping / insuffi-
cient suction power
Sweeping performance not
satisfactory
Activation of side brushes
not working
The side brushes are not run-
ning
Waste container emptying
does not work
Note
In case of all malfunctions not listed, contact Customer Service!
Malfunction
108
Remedy
 Empty the waste container.
 Switch on the suction fan.
 Check the hose on the suction fan.
 Check / replace the seals:
a Suction fan sealing collar.
b Filter chamber seal.
c Waste container seals.
 Check / clean / replace the dust filter.
a Check that the dust filter is firmly in place.
b In case of light soiling, clean the dust filter.
c In case of damage or heavy soiling, replace the dust filter.
 Check the sealing strips for wear / set / replace them.
 Check the roller brush and side brush for wear, replace them as necessary.
 Check the sealing strips for wear, replace them as necessary.
 Check that the coarse dirt flap is fully functional.
 Check that roller brush halves are correctly in place.
 Check the filling level of the hydraulic oil tank.
 Check the hydraulic system for leaks.
 Contact Customer Service.
 Check the filling level of the hydraulic oil tank.
 Check the hydraulic system for leaks.
 Check the side brushes for any tangled pieces of tape.
 Contact Customer Service.

Error messages for symbol displays

Cause
Coolant temperature is too high.
Hydraulic oil temperature too high.
Hydraulic oil temperature too low.
Engine oil pressure is too high.
Parking brake active.
Low fuel level.
Battery is not charging.
Regeneration process required.
Service required.
Remedy
 Switch off the motor.
 Clean the radiator (see chapter "Cleaning the radia-
tor").
 Check the level of coolant in the motor, refill as neces-
sary.
 If the warning light does not go out within 5 minutes:
a Switch off the engine
b Contact Customer Service
 Operate the engine in idling mixture until the warning
light goes out.
 Carefully warm up the engine until the warning light
goes out.
 Call Customer Service.
 Release the parking brake.
 Top up the fuel.
 Vent the fuel system if the tank was run dry.
 Call Customer Service.
 Perform regeneration (see chapter "Regeneration").
 Have the device serviced by Customer Service.
a The service display must be reset by Customer Ser-
vice.
English