Working With The High-Pressure Cleaner (Ex-Factory Option) - Kärcher MC 130 Manual Del Usuario

Sweeping system
During winter use, the sweeping system and suction mouth must
be disassembled and placed into storage.
Working with the high-pressure cleaner (ex-factory
Intended use
Use the high-pressure cleaner only for the following activities:
 Cleaning with the high-pressure jet without detergent (e.g.
façades, park seats, garden paths).
 Only operate the high-pressure cleaner with the flat jet nozzle
provided.
 This high-pressure cleaner is intended and tested for the ex-
clusive use with the sweeper vacuum MC 130.
Pressure relief valve
When the water quantity is reduced via the pressure/quantity
control on the trigger gun, the overflow valve opens and part of
the water flows back to the suction side of the pump.
Safety valve
The safety valve opens when the permissible operating pressure
is exceeded and the water flows back to the suction side of the
pump.
Device elements
Trigger gun
1
Pressure and quantity regulation
2
Spray lance
3
High-pressure hose connection
4
Nozzle holder
5
High-pressure hose storage compartment
6
High-pressure hose
7
Fastening high-pressure hose
8
Fastening trigger gun
9
Fastening trigger gun
10
Trigger gun lever
11
82
option)
Water inlet from water reservoir
1
Stop cock
2
High-pressure cleaner hydraulic connection
3
Water inlet for high-pressure pump
4
Connection to a drinking water line
WARNING
Return flow of dirty water into the drinking water network
Health risk
Observe the regulations of your water supply company.
According to applicable regulations, the device must never be
used with the drinking water network without a system separator.
Use a system separator from KÄRCHER or a system separator
as per EN 12729 Type BA. Water that has flowed through a sys-
tem separator is classified as undrinkable. Always connect the
system separator to the water supply and never directly to the
water connection on the device.
Before initial startup
WARNING
Risk of injury from high-pressure jet
Do not direct the high-pressure jet at persons, animals, live elec-
trical equipment or at the device itself.
Protect the device high-pressure cleaner frost.
ATTENTION
Environmental pollution through oil
Clean engines only at locations having an appropriate oil separa-
tor.
Note
Only nozzles of the sizes listed in the technical data may be used.
If you have not already done so:
1. Connect the high-pressure hose and spray lance.
2. Connect the water supply hose and open the stop cock of the
water inlet.
Operation
Note
The high-pressure cleaner may be operated only at an engine
speed of 1600 rpm and only in work mode.
1. Check the water filling level and fill the water reservoir of the
MC 130 if necessary.
2. Open the stop cock of the water inlet.
3. Put travel direction lever in the NEUTRAL position - centre po-
sition and start the motor.
4. Remove the trigger gun and high-pressure hose from storage.
5. Switch on the PTO work hydraulics.
English
Safety information
Operation